Categories

False alarms and system glitches can be frustrating, and even worse, might prevent your home’s security from doing its job effectively. Luckily, most problems, from false alarms to dead batteries, are easy to remedy. Explore our tips for troubleshooting your home alarm system in Greenville. We’ll help keep your household safe and your system operating the way it should.

Test Your Home Security System In Greenville

One of the most sensible ways to troubleshoot your property’s defense is to test it yourself! Modern systems allow you to place them in test mode to keep you from initiating an emergency response from monitoring agents. After switching to test mode, do the following:

• Arm your system as you normally would when you leave.
• Open a window or door protected by a contact sensor, or test other equipment. Close the window or door once you’re finished so it doesn’t trigger the alarm as you switch the system back on.
• Allow the alarm to go off for 60 seconds to ensure communications with the security company and to create an entry in the alarm activity log.
• Continue testing equipment as needed
• Inspect the alarm’s activity log to validate that everything’s working.

Don’t worry, monitoring specialists will be aware that your system is undergoing a test. Just make sure to switch off test mode when you’re done. It’s wise to test every other month or anytime you change your home’s internet or phone provider.

Evaluate The Placement And Condition Of Motion Detectors

Although an essential aspect of your alarm system, motion detectors are notorious for false alarms. Do your part to prevent them with some simple troubleshooting.

• Perform a visual inspection. Are there items that could shift within the sensor’s detection range, like drapery blown in a breeze?
• Is the sensor covered in dust? Grime, dirt, and cobwebs can result in issues. Check to confirm the sensor is clean.
• Does the motion detector offer pet immunity you can turn on? Some models can be configured to disregard pets up to 100 pounds.
• When was the battery replaced? Low batteries can affect performance or result in false alarms.
• Is a heat source impairing the sensor? Too much heat from direct sun or a fireplace can cause an alarm.

Keep Batteries Ready And Pay Attention To Low Battery Warnings

One of the great aspects of modern home security systems is that they’ll notify you when batteries are dying. If your system has a app or control panel, you’ll usually find alerts there. Depending on the alarm, you might hear an intermittent beep when batteries are low. 

Motion sensors, contact sensors, smoke detectors, and other wireless devices have batteries that need to be replaced every so often. It’s best to keep batteries ready and set a replacement schedule. Some systems also include a backup battery for the primary control panel. This backup helps keep your system functioning if you lose power and should recharge once power is back online. If it doesn’t, you will need to replace it.

Troubleshooting Is Simple With ADT Home Security In Greenville 

As the foremost name in home security, ADT builds systems that supply superior functionality and protection. Switching to test mode is simple through MyADT.com or the ADT+ app, and you’ll always be sent updates when a battery is running low. Get in touch with Secure24 Alarm Systems, an authorized ADT dealer, to find out more and design a system perfectly suited to your Greenville home and family. Call (864) 362-5081 or complete our form today!